Minutes of the CLIC Meeting - 24 June 2005
Agenda:
|
Pressure Distribution
Calculations for CLIC Accelerating Structures
Report from
RF'05 workshop, Kalamata, June 13-17
|
Speakers:
|
Pedro Costa Pinto, Erk Jensen,
Alexej Grudiev |
Pedro presented Pressure distribution calculations for the
PETS system and the accelerating structure.
The vacuum network was modelled by an
electric circuit analogy to allow easy analysis by PSpice. The 30 GHz
accelrating structure and half of the 30 GHz waveguide were modelled.
For the static vacuum distribution, the ratio of the vacuum in the
structure and the waveguide was comparable to measured values, though
the level was 20x lower in the simulation indicating that the
assumption of a well baked system is too optimistic.
Then the transient behaviour for single and repetitive sparks was
modelled. The vacuum levels are much too low in the simulation but the
time constant is of the correct order of magnitude.
In order to proceed the comparison to experimental data, a higher
acquisition rate is needed, the Penning gauge used is not fast enough.
The installation of a different gauge is feasible for the 2nd run this
year.
copy of Pedro's
transparencies (pdf
format or PowerPoint format)
Erk
and Alexej reported on the Seventh International High Energy Density
and High Power RF Workshop (RF 2005), 13 - 17 June 2005, in
Kalamata, Greece.
Back to the
CLIC meeting Home page
Frank
Tecker - Last updated 06-07-2005